Secant Cardio IIe Guía de usuario descargar pdf (Pagina 9)

Use of CARDIO

To bypass zones, simply press the zones to be ignored (these zones are now crossed out)

Press to return to the preceding screen (zones are still crossed out)

To test the siren, press the button, the siren will start for 3 seconds.

Make sure that all zones are ready to disarm except for bypassed zones. The system cannot be armed

as long as zones are still open (open zones appears in left column). Once this column is blank the

system is ready to be armed.

Use the keypad to enter the access code; * asterisks appear in the upper corner of the screen to validate

each number entered. If the code utilized is not valid, the message “INVALID CODE OK” appears. Press

OK, then re-enter the valid code.

A beep indicates that the alarm system has been armed (except for the bypassed zones). Exit the house

within the time delay pre-programmed during installation.

To disarm the alarm system (a beep sounds for the duration of the entrance time delay) enter a valid

access code. Another beep will sound and the message “SECURITY DISARMED” shows that the alarm

system has been disarmed.

To disarm the alarm system, Cardio automatically brings up the keypad shown on page 6, and waits for

the valid access code to be entered. If the code is invalid, the message “CODE INVALID OK” appears.

Press anywhere on the screen and re-enter the correct code.

NOTE: It is strongly recommended to test the correct operation of the security system on a regular

basis.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 42 43

Sin comentarios

Secant Cardio IIe Guía de usuario Pagina 9