Secant Cardio IIe Especificaciones descargar pdf (Pagina 8)

Installation procedure

1- Security equipment installation

1) Select alarm detectors and sensors according to needs and location.

2) Check correct location of all security equipment and install them.

3) Wire all security devices to the CARDIO controller (do not make connection yet).

4) Installation and connection of doorbell and siren.

5) Individual testing of security sensor (use an Ohmmeter and a battery).

2- Touch panel and key reader installation

1) Check correct location of touch panel(s) and electronic key reader(s) and install them.

2) Wire the SNet Bus for the touch panel and the digital key readers (see schematic section p.36).

3) Check the bus for short or problem (see troubleshooting section p.30)

ATTENTION!: for the bus wiring, we strongly recommend to use a twisted pair of wire from a

cable No 18awg unshielded (CAT-5 or 5e).

3- Temperature control installation

1) Check the kind of heating/cooling system to be connected to CARDIO (refer to their respective

technical notice for proper installation and connection).

2) Install relays, safety thermostats, etc.

3) Connect high/low voltage wiring to relays, thermostats, etc. (see schematics section for each type

of heating system).

4) Check functionality of the heating/cooling system before connecting to CARDIO.

4- Control module installation (light, load, shade) if any.

1) Check loads to be controlled (type, power) and their respective specifications.

2) Check the kind of control module to be connected to CARDIO. (see their respective technical

notice for proper installation and connection).

3) Install control module and switches.

4) Wire high and low voltage for the module and switches.

5) Wire the communication Bus for the module to CARDIO.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 52 53

Sin comentarios

Secant Cardio IIe Especificaciones Pagina 8