Secant Cardio IIe Especificaciones descargar pdf (Pagina 9)

Installation procedure

5- X-10 compatible module installation (if any)

1) Check loads to be controlled (type, power) and their respective specifications

2) Codes and install all X-10 modules.

3) Local testing of each module (toggle switch on module (ON/OFF/DIM))

NOTE: Test each module from the very same outlet as the TW-523 using an X-10 compatible remote

control. Select proper house-code on the remote for this purpose.

6- Telephone installation (touchtone only)

1) Install the RJ31X (CA38A) between CARDIO and the home telephone line

2) If there is an ADSL internet connection in the house, install the ADSL filter between CARDIO and

the RJ31X module

7- CARDIO IIé central controller installation

1) Install (but not connect) the central controller and its transformer.

2) Connect the SNet bus.

3) Turn the home main breaker OFF.

4) Connect the transformer and the battery.

5) Turn the home main breaker ON (the full system is now operating, the screen lights up and the

countdown starts running.

6) Turn the home main breaker OFF again.

7) Connect all temperature wires on motherboard.

8) Connect all security wires on motherboard.

9) Plug CARDIO’s X-10 control wire (4-wire type of telephone cable) into the TW523 module (if any).

10) Plug CARDIO’s telephone cable (8-wire type of cable) into the RJ31X (CA38A).

11) Turn the home main breaker ON and do a system restore (see restore section).

8- CARDIO IIé programming

Once CARDIO and all its peripheral units installed, it is time to proceed with the programming. Go through

the following pages to set-up the system configuration. Please note that it is important to perform a good

programming to ensure proper functioning of CARDIO and its peripherals.

NOTE: For any trouble or problem, please refer to the troubleshooting section at the end of this manual.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 52 53

Sin comentarios

Secant Cardio IIe Especificaciones Pagina 9